5 / 16
Propeller 8040
9. Install hinge control horns to reserved position
on main wings, secured by 4pcs PB2*12 screws.
Then install push rod(40mm) to the servo on
each main wing, through the third hole counted
from servo arm edge, secured by a PWA2.3*4
screw.
Secure the clevis to the hinge control horn by
the second hole counted from the horn edge,
tightened by the rubber ring.
10. Install the motor to the motor mount with 4pcs
PM3*6 screws.
Then connect the motor mount to the fuselage
tower position, secured with 5pcs PA2.6*8
screws.
11. Install the propeller to the motor by the order as shown above.
Motor Shaft
Adaptor
Adaptor Nut
Propeller Washer
(5mm Inner Diameter)
Propeller Washer
(5mm Inner Diameter)
Propeller Washer
(6mm Inner Diameter)
Propeller Washer
(6mm Inner Diameter)
Cap
Propeller 8040
Motor With Shaft
Cap
* Step 7-8 For Ranger 2000
7. Slot the two wing connecting rods to one wing,
then connect another wing through the holes of
the fuselage.
8. Secure the wings to the fuselage with the
"click & plug" plastic pieces. Make sure you hear
a "click" sound to secure well.
Ranger 1600
Ranger 2000