VoIP Wireless Router User’s Manual
34
2-3-6 Hot Line
General Settings
→
Hot Line
Enable:
Tick the check box to enable a line. If some lines are not used, disable them (Pause Function) to
avoid unnecessary waiting when an incoming call is diverting to the line.
Hot Line:
Check to direct the call automatically to a pre-configured destination without any action when the
FXS is off-hook. (ie. as the user picks up the phone). When the FXS is under Hot Line mode, no other
phone numbers can be dialed.
Hot Line No.:
Enter the number for pre-defined destination.
Warm Line:
Enter the time for the call to start with a pause, so the user can dial another number. The call
will be automatically directed to the pre-configured destination within timeout period.
FXS Group :
When there is an incoming call and the gateway will automatically assign an unassigned call
according to the Hunting Priority. If Port 2 does not want to be set as an assigned line to receive any
inbound calls, the function can be disabled.
PSTN Busy-Out with FXS Pick-up:
It is to reject calls from PSTN while FXS is off-hook. ‘0’ is disabled this
feature
VoIP Call Allow PSTN In:
It will allow an incoming waiting call from PSTN while VoIP call is in use. To
enable this feature, following settings need to be done first:
1. Tick “VoIP Call Allow PSTN In” to allow a waiting call from PSTN.
2. Tick “Call Hold” to hold the VoIP call when pressing the FLASH button on the phone set. (Calling
Feature
→
Call Hold).
PSTN Call Allow VoIP In:
It will allow an incoming waiting call from Internet while PSTN call is in use. To
enable this feature, following settings need to be done first:
1. Tick PSTN Call Allow VoIP In to allow a waiting call from VoIP.
Tick Call Hold and Call Waiting when pressing the FLASH button on the phone set to answer the VoIP call.
(Calling Feature
→
Call Hold and Call Waiting)
Ring count before FXO Pick up :
It is used to set the ring count before FXO pick-up. For detecting Caller
ID, please set it as 2. FXO ports are off-hook after 2 ring counts.
