A
B
B
A
Toe-side
Heel-side
(Figure 8)
.25”/
6.35mm
6.35mm/
.25”
0º
0º
6.35mm/
.25”
.25”/
6.35mm
B
B
A
A
Tip of Board
Tail of Board
(Figure 9)
0º
0º
Stance
Width &
Angles
(continued next page)
Keep It Tight
(Figure 12)
(Figure 13)
Stance Location
Window
(Figure 14)
(Figure 15)
3
voile.com
(Figure 10)
Disk Reference & Guide
A
B
A
B
(Figure 7)
A
B
A
B
The slots in both the In-Line Disk and The
Parallel Disk are intentionally placed off
center in relationship to the disk. Each disk
is marked with the letters A and B to
indicate the orientation of the disk. Rotating
the disk 180 degrees will shift the position
of your binding mount and may be neces-
sary to achieve your desired stance.
(See Figure 7)
It is recommended to use the In-Line Disk on your heel-side puck. The mark
labeled B will mount you more heel-side, up to .25”/6.35mm. The mark
labeled A will move your mount more toe-side.
(See Figure 8)
It is recommended that you use the Parallel Slot Disk for the toe-side puck.
The mark labeled B will move your mount towards the tail of the board. The
mark labeled A will move you toward the tip. (See Figure 9)
1.) Locate Puck Alignment Guide, 4 Pucks, 4
Rubber Puck Gaskets, 2 Parallel Slot Disks,
2 In-Line Slot Disks and 8 M6x12mm
Pan-Head Screws.
(See Figure 10)
2.) With interlocking hooks on tip and tail
kept tight, mark where you want your stance
on the board. Tip: Use a clamp to keep hooks
tight. (See Figure 11 and 12)
3.) Place rubber gaskets on all 4 Pucks.
(See Figure 13)
4.) Place 2 assembled Pucks with gaskets
into the Alignment Guide and place over
your front foot stance mark. Use stance
location window to ensure you’re on your
mark. (See Figure 14)
5.) Using a hard surface for setup, set your
front foot first. With the Puck Alignment
Guide centered over your stance mark, place
an In-Line Slot Disk on your heel-side Puck
at your desired angle and locate over appro-
priate inserts. (See Figure 15)
Mark Stance
(Figure 11)
