Void ARCLINE 6, Руководство пользователя

Страница: 3 / 10

Arcline
Page 3
Reference Manual
Features
Close tolerance and durable components provide increased reliability and greater output.
Accurately machined multi laminate birch plywood cabinets for superior strength.
120 degree wide dispersion for maximum coverage.
Self contained flyware system with tilt adjustment in 2 degree steps.
Components emanate from a single point to form a virtual arc, increasing HF extension and throw.
Built in Electronic protection device for the HF drivers.
Tough kick proof grills with foam filters protect the components from the heaviest of abuse.
Three year warranty and guarantee.
System Connections
Arcline 6 has two inputs on its rear panel. When using an Arcline 6 with Arcline X subs, connect the
Arcline X to an amplifier or amplifiers that use pins +1, -1 for the low output and pins +2, -2 for the mid hi
output. Use a short cable wired +2, -2 to +2, -2 to connect from the Arcline X to the connector marked
INPUT on the Arcline 6. If a separate cable is used from an amplifier to connect directly to an Arcline 6,
use a cable wired +1, -1 to +1, -1 and connect to the input marked INPUT on the Arcline 6.
When linking two Arcline 6's, connect via the INPUT and LINK OUT connectors on both speakers. A
cable wired +1, -1 to +1, -1 must be used when linking via the INPUT and LINK OUT connectors.
Each Arcline 6 has a nominal impedance of 8 ohms. An amplifier capable of delivering between 750 to
900 watts rms to each Arcline 6 is recommended.
System Assembly
Place an Arcline X into its desired position and place another Arcline X on top. Insert the winch up tower
though both Arcline X subs making sure the winder handle faces rearwards. Next mount the craddle on
to the top of the winch up stand. Extend the front mounting bars and insert the locking pins on one of the
Arcline 6 enclosures. Lift the Arcline 6 on to the cradles bottom bar then lift the Arcline 6 until both front
mounting bars are lined up with the cradles front mounting points. Insert both locking pins. Fit the rear
mounting bar, adjust the tilt and then insert the locking pins. If a single Arcline 6 is to be used in a craddle
insert 2 locking pins into the cradles telescopic tubes. If a further Arcline 6 is to be used, push the Arcline
6 up vertically until the telescopic tubes are fully extended and insert both locking pins. A further Arcline 6
can now be mounted under the top Arcline 6 by use of the mounting bars and locking pins.
During transit the locking pins can be store in the holes marked 'transit lock'. Doing so will stop any
movement of the connecting bars during transit and reduce the risk of losing the locking pins.
Precautions
Please consider the following precautions during use :
1. Install Arcline 6 in a dry environment, do not expose the cabinet to rain or moisture.
2. When flying or mounting Arcline 6 ensure safe working practices and follow the recommended
rigging guidelines. Check the flying system regularly for any defects or lose bolts and replace any
worn or damaged pins.