PFW 6875
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
www.vogels.com | Europe +31 (0)40 26 47 400
1)
Insert a small straw or toothpick into the threaded inserts found on the back
of the flat-panel.
2)
Use a pencil to mark the depth of the threaded insert on the small straw or
toothpick.
3)
Mark the straw or toothpick 1/8” (3.175 mm) above the depth of the threaded
insert, as shown in Figure 1.
4)
Insert the small straw or toothpick into the remaining threaded inserts to
compare and verify their depth using the straw or toothpick’s 1/8” (3.175 mm)
allowance mark.
5)
Locate the correct diameter screw for the threaded insert.
If the screw you selected is longer than the 1/8” (3.175 mm) allowance
mark on the small straw or toothpick, as shown in Figure 2 and Figure 3,
do not use this screw. The screw length must not bypass the mark.
6) Test each size of the screws provided.
The correct screws should thread easily into themounting point and not pull
out when tension is applied.
Small Straw or Toothpick
Marking the 1/8”
Allowance
Small Straw
or Toothpick
Small Straw
or Toothpick
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
Selecting the Mounting Hardware
Securing the Adapters
Optional adapters are available with your PFW 6875 mount.
Secure the adapters to the PFW 6875 brackets with the
supplied M8 washers and Nuts.
M8 Nylon
nut
M8 Washer
Page 7
