Installation
Instructions
Page
7
PFW 6854
Concrete Mounting
Concrete anchors must be used for concrete installation. They can be purchased at your local hardware store. The
mounting surface must be a minimum 6” thick.
For the two upper mounting points, the Griplate™ flat side must be facing up. For the two lower mounting points,
the Griplate™ flat side must be facing down.
IT WILL TAKE TWO PEOPLE TO COMPLETE THE NEXT INSTALLATION STEP.
1.
Begin by placing the mount into position against the wall, keeping it level.
2.
Mark off four holes to be used for securing the mount.
3.
Next, drill holes using a masonry bit for your anchors (recommended masonry bit).
4.
Insert a commercially available concrete anchor into each hole (recommended 3/8” anchors).
5.
If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall.
6.
Once all of the anchors are in place, move the wall bracket into position.
7.
Attach the nut onto the threaded shaft that is protruding from the wall.
8.
Do not tighten until all nuts are in place.
5.
At this time, center the universal bracket bar and tighten the set screws that are located on the universal brackets.
Universal Mounting Bracket Assembly
1.
Place the universal bracket bar and the universal brackets on a flat surface.
2.
Slide the universal brackets onto the universal bracket bar (as shown below) with the set screws facing up. At this
time, do not tighten the set screws that are located on the universal bracket.
3.
Place the display on a soft, flat surface, face-down. Next, place the universal bracket assembly on the back of the
display, with the universal brackets resting directly over the display mounting points.
4.
Once the desired position has been determined, place the Griplate™ washers over each mounting point and secure
them using the appropriate hardware (see Page 5).
Universal Mounting Brackets
Set Screw
Griplate™
Universal Bracket Bar
Griplate™
D IM P L E S
F A C IN G U P
D IM P L E S
F A C IN G D O W N
D IM P L E S
F A C IN G U P
D IM P L E S
F A C IN G D O W N
M4
M8
M6
M5
