Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
PFW 6851
www.vogels.com
19
20
Ajusting the Flat Panel Tilt
Plastic Channel Cover Installation
TO ADJUST THE TILT TENSION OF THE PFW 6851, LOOSEN THE TENSION BOLTS LOCATED ON THE BOTTOM RIGHT AND LEFT SIDE OF THE
MAIN ARM ASSEMBLY. RE-TIGHTEN THESE BOLTS TO ACHIEVE YOUR DESIRED TENSION.
Tension
Bolt
Tension
Bolt
Adjusting the Flat Panel Down
Adjusting the Flat Panel Down
Step 1.
Place one hand at the center top edge of
the flat panel.
Step 2.
Place the other hand on the center bottom
edge of the flat panel.
Step 3.
Using the upper hand, gently pull the top
of the flat panel away from the wall while
the lower hand gently pushes the bottom of
the flat panel towards the wall.
Step 1.
Place one hand at the center top edge of
the flat panel.
Step 2.
Place the other hand on the center bottom
edge of the flat panel.
Step 3.
Using the upper hand, gently push the top
of the flat panel towards the wall while
the lower hand gently pulls the bottom of
the flat panel towards the wall.
Side Cover
(Long)
Center Cover
(Short)
Side Cover
(Long)
Step 1.
Place the plastic channel covers over the
Mounting plate (2 side covers and 1 center cover).
Step 2.
Gently push each cover into place, covering the mounting
slots of the mounting place.
Repeats steps 1 and 2 for the installation for
of the lower plastic channel covers.
Page 10
95V0-000-016-0X_1
