vogel's PFW 6851, Руководство по установке

Страница: 8 / 14

Page 8
PFW 6851
Determining the Mounting Hardware
Step 7.
Once all of the anchors are in place, move
%
Step 8.
Attach the nut onto the threaded shaft that
is protruding from the wall.
Step 9.
Re-level the wall plate and tighten all
concrete wedge anchor nuts at this time.
"< >"
hardware, please follow the installation instructions as provided with that hardware.
!;:%
Threaded
Shaft
Nut
Level
Do NOT over-tighten the concrete wedge anchors.
Small Straw or Toothpick
Small Straw
or Toothpick Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
n
Insert a small straw or toothpick into the threaded inserts found on the
o
Use a pencil to mark the depth of the threaded insert on the small straw or
p
Mark the straw or toothpick 1/8” above the depth of the threaded insert, as
q
Insert the small straw or toothpick into the remaining threaded inserts
to compare and verify their depth using the straw or toothpick’s 1/8”
r
If the screw you selected is longer than the 1/8” allowance mark on the
small straw or toothpick, as shown in Figure 2 and Figure 3, do not use
s
The correct screws should thread easily into the mounting point and not
You must account for the bracket, spacers and Griplate™
depths when using the Thread Depth Indicator to measure