Installation
Instructions
Page
13
PFW 6851
TO ADJUST THE TILT TENSION OF THE PFW 6851, LOOSEN THE TENSION BOLTS LOCATED ON THE
BOTTOM RIGHT AND LEFT SIDE OF THE MAIN ARM ASSEMBLY. RE-TIGHTEN THESE BOLTS TO ACHIEVE
YOUR DESIRED TENSION.
Adjusting the Flat Panel Tilt
Step 1.
Place one hand at the center top edge of
#
Step 2.
Place the other hand on the center
"#
Step 3.
Using the upper hand, gently pull the
#
while the lower hand gently pushes the
#
wall.
Step 1.
Place one hand at the center top edge of
#
Step 2.
Place the other hand on the center
"#
Step 3.
Using the upper hand, gently push the
#
while the lower hand gently pulls the
#
wall.
Adjusting the Flat Panel Down
Adjusting the Flat Panel Up
Plastic Channel Cover Installation
Side Cover
(Long)
Center Cover
(Short)
Side Cover
(Long)
Step 1.
Place the plastic channel covers over
the mounting plate (2 side covers and 1
center
cover).
Step 2.
Gently push each cover into place,
covering the mounting slots of the
mounting
plate.
Tension
Bolt
Tension
Bolt
Repeat steps 1 and 2 for the installation
of the lower plastic channel covers.
