Vogels Autogas Systems VGI Hardware Manual
System Description and Installation
VGI Technical Manual 2014-01-14.pdf
Pagina 17 van 44
1.8.4 Injectorrail installation instructions
Follow the procedures for installing the injector rail, as shown below:
-
The injector rail has two 6mm holes for fitting the unit using the support provided in the kit.
-
It will be necessary to place the tubes with the 6-mm interior Ø on the injector output to connect the injector
with the nozzle placed on the inlet manifold. (see Chapter that describes the nozzle)
-
There is a tight correlation between the location of the injector rail and the nozzles.
-
Place the injector rail close to the inlet manifold in such a way that the connection tubes can be as short as
possible and so that the nozzles can easily be connected without kinks.
-
The injector rail/manifold tubes must be no longer than 18 cm.
-
The difference in length between the tubes must not be greater than 4 cm.
