The replacement for coolant
·The coolant drainage：
–
.
Keep the motorcycle upright by standing rack
–Lay a liquid tray under the engine.
–Remove the water drainage bolt (Figure 1), because
all the heat radiation system is connected, so all the
coolant may flow out from this port.
–After the old coolant drained off, install and fasten
the water drainage bolt in place.
·The coolant filling-up：
–The coolant need be filled up from the heat radiator
and expansion tank the two positions
.
–
.
Open the tank cap (Figure 2) of heat radiator and fill up with the coolant
–Check the full filling-up of coolant from the tank cap of heat radiator, pinch
the water tube (Figure 4) when filling up to exhaust until it is full, then well cover the tank cap.
–A
fter the tank'
s cap of heat radiator covered, start and run the engine for 30 seconds to make the cool
ant fully reach every position need it.
–M
ake the engine stop, after the engine cooled down, open once again the tank's cap of heat radiator
,
check if the coolant alrea
dy was full, in case the level fell down, please fill up once again until it is full,
then well cover the tank's cover of heat radiator, repeat this action until it gets full, in case it is
necessary, it may need to repeat two times or more.
–Remove the white rubber cap (Figure 3) of expansion tank, then fill up with coolant through special
rubber tube to the level between scale mark UPPER and LOWER.
Filling-up port
Inlet tube
Outlet tube
Drainage bolt
Figure
1
Rubber cap
59
Figure
3
Figure
2
Figure
4
