Installation Instructions
ulo |
507
© 2018 Vode Lighting LLC. All rights reserved. | 21684 8th Street East, Suite 700, Sonoma, CA 95476 | 707.996.9898
ulo | 507 | Installation Guide | August 2019 | Rev A •
10
Mini-Mount (
MM
)
Surface must be clean, dry and flat.
Mini Mount base is provided with mounting tape. Remove tape backing and install to desired surface. Once
placed, press down firmly to secure in place. Vode recommends waiting 24 hrs for mini-mount to fully adhere
to the surface.
Gently place the light bar onto the mounting arm with dome magnet face down. Caution: Risk of pinching.
Ensure fingers are clear of magnets.
Plug the light bar cord into your selected power supply.
Remove protective film from lens and use the
proximity sensors to control the system.
The front sensor controls the light level and the back sensor
controls the color temperature (CCT).
Removal of Mini-Mount
-
Apply a few drops of rubbing alcohol between the Mini-Mount and the surface it has been applied to.
Carefully use fishing line or dental floss in a sawing motion to cut foam away from the surface. Do not use
sharp edges to remove adhesive as it may result in scratches or damage to surface. Once removed,
Mini-Mount can not be re-installed. Vode is not responsible for any surface damage resulting from improper
removal of Mini-Mount from the mounting surface.
Remove tape
backing
Light
Level
CCT