10
Getting Connected
The Silent Symphony is easily wired into any situation. Just follow the steps below to get connected:
1 . Attach the antenna to the ANT jack on the Silent Symphony .
2 . Connect the included RCA jacks from the Audio Output on the music source to the RCA Audio Input
located on the Silent Symphony transmitter .
3 . Select the Transmission Power Level:
a . High
b . Low
4 . Select from one of the three available frequencies to broadcast on with the Channel Select switch .
5 . On the headset receiver(s), insert two (2) AAA batteries into the battery compartment .
6 . Power the headset receiver(s) on and select the appropriate channel to listen with the Tune button .
7 . Adjust the headset receiver volume to a comfortable listening level .
With this setup, any audio that is fed into the transmitter will be broadcasted wirelessly to all headset
receivers tuned to the same channel and that are within its operational range .
Note: The transmitter will power off if no input signal is detected after 5 minutes.
CHARGING THE TRANSMITTER
The Silent Symphony transmitter has an onboard internal battery for remote applications . The included power
adapter should be used to charge the internal battery .
• The LED will stay on while the internal battery is charging .
• The LED will go out once the internal battery is done charging .
(Left Ear)
Insert 2 AAA Batteries
Attach Antenna
1/8” Audio Output
(Latop, Smartphone,
MP3 Player, etc.)
RCA Output
(Mixer, TV, etc.)
Select Power
(Left Ear)
Power On
(Right Ear)
Select Tune
Select Channel
(Right Ear)
Select Volume
