Setting up the speakers and speaker stands
1. Setup each SS-88 speaker stand by extending the support
legs to a position that is stable and tighten the tension mecha-
nism firmly.
2. Place a VX-15 speaker on top of the SS-88 so that the
shaft of the SS-88 fits flush into the mounting cavity on the
bottom of the VX-15.
NOTE: Each end of the SS-88 pole has a particular diameter
fitted for common speakers’ mounting cavities. If the SS-88
shaft does NOT fit flush into the mounting cavity on the VX-15,
loosen the SS-88 pole and reverse it in the stand and then
remount the speaker.
3. Repeat the above steps for each speaker and stand.
Connecting Power
Be sure that each product has a power cord firmly attached. It is recommended that you use a power strip/surge protector
when connecting your CLUB-3800 to a power outlet.
Connecting the components
Once you have mounted all of the components into the RC-8, it is time to connect them. Follow these directions on connect-
ing the components.
NOTE: If you are also connecting components that are not part of the CLUB-3800 system, please refer to the manual of that
product for setup instructions.
MAKE SURE THAT ALL PRODUCTS’ POWER IS
TURNED OFF BEFORE CONNECTING ANYTHING
VX-15 Speaker
SS-88 Stand
CDG-9000 PRO remote unit to the player unit
Connect the Control Interface Connector from “CONNECT TO MAIN UNIT” jack on the rear panel of the remote unit to the
“CONNECT TO REMOTE CONTROLLER” jack on the rear panel of the player unit.
CDG-9000 PRO Controller
CDG-9000 PRO Player
1
