To use the MIDI Drawbar as a continuous controller: connect the device receiving MIDI data to MIDI OUT of the
MIDI Drawbar. The MIDI Drawbar MERGE IN allows another MIDI controller's MIDI out to be connected and
merged with the data generated by the MIDI Drawbar.
The functions of the push-button switches when used as a continuous controller are as follows:
1. VIBRATO / CHORUS ON
- sends MIDI control number 95.
2. VIBRATO / CHORUS SEL
- sends MIDI control number 93. The functions for the various data values are the
following:
MIDI DATA
VALUE SENT
FUNCTION
18
Vibrato Mode, level 1 (C / V 1 Lit,
CHORUS Off)
36
Vibrato Mode, level 2 (C / V 2 Lit,
CHORUS Off)
58
Vibrato Mode, level 3 (C / V 3 Lit,
CHORUS Off)
79
Chorus Mode, level 1 (C / V 1 and
CHORUS Lit)
100
Chorus Mode, level 2 (C / V 2 and
CHORUS Lit)
122
Chorus Mode, level 3 (C / V 3 and
CHORUS Lit)
3. ROTATING SPEAKER ON
- sends MIDI control number 94.
4.
ROTATING SPEAKER FAST
- sends MIDI control number 68. The foot-switch will also toggle this control.
5.
PERCUSSION ON
- sends MIDI control number 73.
6. PERCUSSION VOLUME
- sends MIDI control number 71.
7. PERCUSSION DECAY
- sends MIDI control number 70.
8. PERCUSSION 2ND/3RD
- sends MIDI control number 72.
9. RE-XMIT / SAVE -
is a dual-function button. The first function is to send the state of all of the MIDI
DRAWBAR's controls (drawbars, knobs, and switches) to the V3. This is useful if the V3 state is unknown such as
when the V3 is first turned on or the V3's program number is changed.
The second function of the DRAWBAR /
SAVE button is normally used to save control settings when the MIDI Drawbar is used with the Voce V3. By
holding down the DRAWBAR / SAVE button for approximately four seconds, the MIDI Drawbar unit will send a
MIDI control number 102 with its data byte set to a value of 127. All front- panel indicators will light, indicating the
save function was performed. This function will not re-transmit the controller values unless the button is released
before the four-second period is over.
The functions of the rotary controls when used as a continuous controller are as follows:
