G-106
9
p.
Please reset GeoBox before any new application to avoid unexpected settings in the system. If
deeper reset is required, user can turn on GeoBox and press both [Menu] + [Pattern] key on front
panel and power on GeoBox again for 5 seconds. It will reset the system
q.
To set [Menu Time Out] to “0”, the OSD will appear till the OSD Menu has been turned off
manually or system input timing change.
r.
Default Internal Grid Pattern represents 32x32 pixels no matter which input resolution is selected.
s.
Only HDMI input port can provide HDMI raw signal loop out for daisy chain connection. This loop
out signal has no any processing.
t.
When [Gwarp] PC tool is used, user needs to save the setting into GeoBox through the OSD
menu: [Anyplace]
[Gwarp Pro]
select [UserMap 1-10] to save the settings. Then PC can be
removed.
u.
When Power Off/ON GeoBox, it will maintain the final settings.
v.
User needs to save the final setting into [Profile] under [Options] menu for long tern stored inside
the system. Even the system is reset, the [Profile] settings will be kept without change.
w.
Continuously press PATTERN button, internal test pattern will show different colors for easy
installation: White—Red—Green—Blue—Blank. When in “Blank”, user can see OSD and the
image from signal source. In this case, PC test pattern can be applied.
x.
Please use INFO hot key on front panel or remote controller to check the input and output timing.
The indicators on the front panel will show the input/output connection status.
y.
When OSD is activated and user switches to another processing channel, the OSD will stay active.
Once user switches back to this channel again, user can operate the same OSD menu again. This
is convenient for geometry alignment. User can pop-up the same geometry menu (such as 9x5) in
both processing channels and switch between two channels for quick geometry alignment.
