Valvole brevettate per compressori rotativi a vite e pistoni
Patented valves for piston and screw rotary compressor
V.M.C. s.p.a.
Via Palazzon 35 – 36051 Creazzo (VI) – ITALY
Internet
www.vmcitaly.com
-
Phone
+390444/390444/341115 -
Fax
+390444/275112
TIPO
TYPE
DC
REVISIONE
REVISION
00
DATA
DATE
02/18
GRUPPO
LINE
744
ARTICOLO
ARTICLE
.YX
MODELLO
MODEL
X3
Pagina 36 di 43
6.1
PACK SMART USE WITH SYNTHENTIC OIL
If you want to use synthetic lubricating oils, follow the procedure mentioned here below:
-
Before switching on the Pack Smart and making it work, inject about 0,02 gal of lubricating oil
into the intake valve air inlet and press down the throttle while rotating the rotors manually in the
right direction (
picture 8
). Pay attention not to damage the throttle seal O-Ring (
picture 9
).
-
Extract the mineral oil contained in the Pack Smart through a proper plug (
picture 10
) shows
the plug position)
-
Fill the tank with synthetic lubricant up to the level indicated by the viewer (
picture 10
).
-
Start the compressor for about 5 minutes. In this way, the lubricant will begin to flow through the
circuit (pipes, radiator, filters etc.).
-
Switch off the compressor and discharge all synthetic oil into the circuit through the plug
(
picture 10
).
-
Fill again the tank with new synthetic oil up to the level indicated by the viewer (
picture 10
).
-
Start the compressor for about 5 minutes. In this way, the lubricant will begin to flow through the
circuit (pipes, radiator, filters etc.)
-
Switch off the compressor. Discharge the pressure and top up the lubricant through the proper
fill-up hole up to the level indicated by the viewer (
picture 10
).
WARNING:
if you do not carry out a “washing cycle” as described above, lubricating
problems may arise due to a lubricant mix incompatibility. Handle the lubricant with proper
protection. Dispose of the mineral oil complying with current waste disposal regulations.
