Depósito legal y copyright 2014. Todos los derechos reservados.
5
PRO LIFTS S.L.
SMART TOWERS
USER MANUAL
load onto the lift using an adequate
support according to the need, use so
that the weight of the load will only be
elevated in a vertical direction.
Once this is done, start the SMART con-
trol device pressing the button
S,
all
the control leds will start fl icking (If the
leds do not fl ick, check if the batteries
have power). If the led of the
B
area is
on, replace the batteries (See point 4.
Maintenance).
The control device will turn off auto-
matically after 5 minutes.
3.2 - STABILIZATION CONTROL:
The leds of the
E
area show the sta-
bilization of the towerlift. The central
green led indicates the tower is pro-
perly stabilized. The other 12 red leds
around the central led represent each
leg of the towerlift, if any of these leds
are turned on, the towerlift is not be
properly stabilized.
To fi x the stabilization turn the handles
of the stabilizers, located at the end of
each leg.
3.3 - WEIGHT CONTROL OF THE LOAD:
To make the load cell work properly
the towerlift must have at least one
section without lifting and the cable
must be slack
, the ALS red locks should
take the pressure off the load and re-
lease strain applied on the cable. To
do so, once the towerlift is raised at
the desired height and the last ALS
lock is locked in its corresponding hole,
slack the cable by turning the winch
crank anti-clockwise.
There are 6 red leds on the
C
area,
they show the weight of the load pla-
ced on the forks, each led shows a per-
centage: 0%, 25%, 50%, 75%, 100% and
OVER LOAD. Consult the maximum
load and you will obtain the weight by
observing the red led turned on in the
SMART control device.
The lift should
NEVER
be overloaded.
Safety at work is the most important
issue.
3.4 - HEIGHT MEASUREMENT:
Thanks to the SRS system, unique to
VMB, our towerlift rises each section in
order, being the fi rst section the one
that carries the forks, and so on until
all sections are at a maximum height.
With this unique feature we have been
able to incorporate a measurement
tape located at one side of the tower,
this tape allows you to always know at
what height the forks are, with a sim-
ple glance.
