Vladimir's Models Snipe, Рекомендации по сборке

Страница: 3 / 12

Snipe
Recommendations for assembly
3
Figure 2.6 - Sizing torsion feathers
Figure 2.5 - Insert the torsion bar in the tail
2.3 Inset kylya in hvostovuyu beam
Fix the rudder at zero deflection with masking tape.
For the vertical tail, install it vertical relative to the
stabilizer and wing (Figure 2.8), and center it with respect to
the boom. (JW note: I offset mine about 1 cm upwards
compared to centered). Glue the fin into the groove of the
fuselage with superglue. (Fig.2.9)
When bonding fin note:
- because airfoil is not symmetric, we make two versions
of the fuselage keel with grooves right-handed and left-
handed. Figure 2.7 shows a view on the fuselage below
Figure 2.9 – Bonding fin
Figure 2.7 - Two versions of the fuselage (bottom view)
Figure 2.8 Set fin perpendicular to the axis of the fuselage