VKI Technologies 145-3, Руководство по эксплуатации и обслуживанию

Страница: 6 / 28

Page 6 9703 T.S.S. MANUAL
INSTALLATION INSTRUCTIONS
WARNING: Read and follow installation instructions carefully
before plugging in machine to electrical outlet.
1. Remove machine from shipping carton. It is strongly recommended to perform a visual inspection of the
machine inside out checking for loose connections on either control board or for damage to outlet valve that
might have been caused by mishandling during shipping. Please keep carton and packing in case the brewer
needs to be re-shipped.
2. Plumb in brewer.
PLUMBING INSTALLATION INSTRUCTIONS
CAUTION:
Power to the brewer must be switched off before proceeding with installation.
a) Flush the water lines thoroughly before installing brewer. Brewer should be connected to a
cold water line
for best operation. Check incoming water for adequate pressure. Water pressure should be at least 20
psi.
b) For less than a 25 ft. run, use 1/4" O.D. (outside diameter) copper tubing and connect to a 1/2” or larger
water line. For more than a 25 ft. run, use 3/8” O.D. copper tubing from a 1/2” or larger water line, and
provide an adapter fitting for the connection to the brewer.
c) If water pressure is more than 50 psi, we strongly recommend that you install a water pressure regulator
and set the water pressure below 50 psi. This will prevent erratic water levels in the server.
d) Connect the incoming water line to the incoming main fitting on the back of the brewer.
e) Provide an individual water line to each machine when there are multiple units installed at the same
location.
NOTE:
A shut off valve should be installed on the incoming water line in a convenient
location. This will allow the user to shut the water supply, if needed.
3. Place an empty server under brew basket. Use the sight gauge to make certain it is empty.
4. Plug the brewer into proper voltage circuit and switch the power ON.
5. Water will automatically begin to fill the tank. After water tank has filled, remove the top cover of the T.S.S. by
removing the one screw in front securing it in place.
6. Switch the power OFF .
7. Reconnect heater terminal wires with red tape.