7
VKB Gunfighter Mk.II Quick
Guide - HARDWARE
Replacing the springs - do this for each axis:
(Refer to pg. 5 on how to access the gimbal)
Useful tools: needle-nose pliers, small zip ties, x-acto knife (or cable cutters)
Installing a spring (do this for each axis):
1. Thread a small zip tie down to a small loop.
2. Attach it to the hook of one side of the spring you want to install.
3. Slide the opposite end of the spring’s hook over the cam shaft pin.
4. With needle nose pliers, pull the zip tie to attach the other end of the spring hook over opposite cam shaft pin.
5. Once hooked on, use an x-acto knife (or cable cutters) to cut the zip tie loop and remove it.
Removing a spring (do this for each axis):
6. Thread the end of a small zip tie through the spring hook you want to remove, and pull the zip tie tight.
7. With needle nose pliers, pull the zip tie to remove the spring from the cam shaft pin.
Hint: You might want to use your opposite hand’s thumb to press down on the spring coil while installing or
removing the spring to prevent it from jumping off when released.
