4.1 Button Operation for GPS function
NOTE: “button”
presses must be less than 2 seconds each in all uses
a.
GPS
On:
Press control button 5 times. Call the device SIM number and it is supposed
to get through without answer, it means the device is on.
b.
GPS Off:
Press control button 10 times. Call the device SIM number and it can not get
through, it means the device is off.
c.
LED Torch on:
Short press the button 1 time then long press the button for 3 seconds
to turn on the LED torch function.
d.
Power bank on:
long press the power button more than 3 seconds to turn on the
power bank function, the power LED indicator will show the remaining power.
5. Operation Commands Guide
5.1 Set APN:
(VERY IMPORTANT AND MUST BE DONE 1ST) For the device to
send data to the server, this command MUST be enabled.
SMS:
*apn*AXXX*BXXX*CXXX*
This command sets the telecom
A
ccess
P
oint
N
ame.
BXXX refers to user name, CXXX refers to password.
If there is no user name and password required, send as
*apn*AXXX*
If there is user name but no password required, send as
*apn*AXXX* BXXX*
APN information can be checked on local telecom website.
You will receive the following text: "Notice: APN is set to XXX. User name: XX. Password:
XX”
5.2 Registering the “Master”
Controller
SMS
to the device:
*master*1XXXXXXXXXXXX*
, (For instance, master
controller phone number is +1XXXXXXXXXXXX. +1 refers to the country code.
XXXXXXXXXXXX is the cellphone number. Please make sure country code is included, and
digit 0 is not needed before cell phone number)
Device Response:
"Notice: Cell Phone # xxxxxxxxxx is set to master controller, the
password is 123456.”
(The device has a default password of “123456”
to initially program
in your PDA/Phone.
NOTE: The device will ONLY listen and respond to instructions from this number unless
you choose to turn on the multi controller function and open the device to any cell phone
number.
