–
43
–
LED Error Messages
E
RROR
C
ODE
M
ESSAGES
P
OWER
LED
B
LUE
L
AMP
LED
R
ED
System Initial
Flash
OFF
Ready to Power on (Standby)
ON
OFF
System Power on
Flash
OFF
Lamp Lit , System stable
ON
OFF
Cooling
Flashing
OFF
1W MCU detects scaler stops working (initial fail)
2 blinks
OFF
Over Temperature
3 blinks
OFF
Thermal Break Sensor error
4 blinks
OFF
Lamp Fail
5 blinks
0 blinks
Lamp Temperature shut down
5 blinks
1 blinks
Lamp Short circuit in output detected
5 blinks
2 blinks
Lamp End of lamp life detected
5 blinks
3 blinks
Lamp did not ignite
5 blinks
4 blinks
Lamp extinguish normal
5 blinks
5 blinks
Lamp extinguish run-up
5 blinks
6 blinks
Lamp voltage too low
5 blinks
7 blinks
Lamp ballast Fail
5 blinks
8 blinks
Lamp ballast Communication error
5 blinks
10 blinks
Lamp Fan error(FAN1)
6 blinks
1 blinks
Power Fan error(FAN2)
6 blinks
2 blinks
Blower Fan error(FAN3)
6 blinks
3 blinks
Case Open
7 blinks
OFF
DMD error
8 blinks
OFF
Color wheel error
9 blinks
OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting
the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart
above, please contact your service center.
Image Problems
Problem: No image appears on the screen
1.
Verify the settings on your notebook or desktop PC.
2.
Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1.
Adjust the
Focus
on the projector.
2.
Press the
Auto
button on the remote control.
3.
Ensure the projector-to-screen distance is within the specified range.
4.
Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1.
Position the projector so it is as perpendicular to the screen as possible.
