- 8 -
Rear Panel
Status LED’s
Each time Video Server starts up, it will perform power-on-self-test, abbreviated as POST,
to examine every hardware module. As soon as the administrator plugs in the power
connector both LED’s under the power LED will flash one by one until the diagnosis is
done. If the result is good, both status LED’s will turn off for a while and then follows the
pattern below. If any module fails, refer to the Appendix A for the error pattern and
follow the trouble-shooting procedures. If the system still cannot operate normally,
please contact your reseller for technical service.
Network Interface Condition
LED2 (Heartbeat) LED3 (Status)
before installed
OFF
OFF
after installed
flash
OFF
Ethernet
during camera control flash
Flash
after POST
flash
ON
PPP with modem
before connected
ON
ON
after connected
flash
ON
before installed
OFF
OFF
PPP with null modem
after installed
flash
OFF
Ethernet 10/100 socket
Connect to an Ethernet network with a UTP category 5 cable of length shorter than 100
meters according to the standard. Once the Ethernet cable is connected without error,
Video Server will utilize the Ethernet interface prior to the modem attached to COM2.
Содержание VS2101
Страница 1: ......
