Vivotek FD8361, Руководство пользователя

Страница: 10 / 159

VIVOTEK
10 - User's Manual
Network Deployment
Setting up the Network Camera over the Internet
This section explains how to configure the Network Camera to an Internet connection �
1� If you have external devices such as sensors and alarms, make the connection from the
general I/O terminal block.
2. Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch.
Use a Category 5 Cross Cable when Network Camera is directly connected to PC�
3� Connect the power cable from the Network Camera to a power outlet�
There are several ways to set up the Network Camera over the Internet � The first way is to set
up the Network Camera behind a router � The second way is to utilize a static IP � The third way is
to use PPPoE �
Internet connection via a router
Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below�
1� Connect your Network Camera behind a router, the Internet environment is illustrated below�
Regarding how to obtain your IP address, please refer to Software Installation on page 13 for
details�
N.C.
N.C.
N.C.
AC24V
AC24V
POWER
COLLISION
LINK
RECEIVE
PARTITION 1 2
3 4 5
3
1
2
12V
+12V
Digital output
PIN 1
Power+12V
PIN 2
Digital input
PIN 3
Ground
PIN 4
GND
DI
DO
+12V
N� C�: No Connector
N� C�: No Connector
N� C�: No Connector
AC24V: Power in AC 24V
AC24V: Power in AC 24V
GND: Ground
DI: Digital Input
DO: Digital Output
+12V: Power, 12V DC