VIVOTEK
64 - User's Manual
The Profile mode is not available when the IR cut
filter is configured in the Auto mode.
Please follow the steps below to set up a profile:
1. Select the
Profile mode
tab.
2. Select the applicable mode: Night mode or
Schedule mode. Please manually enter a
range of time if you choose Schedule mode.
3. Configure Exposure control settings in the
folowing columns. Please refer to previous
dicussions for detailed information.
4. Click
Save
to enable the setting and click
Close
to exit the page.
You can click
Restore
to recall the original settings without incorporating the changes. When
completed with the settings on this page, click
Save
to enable the settings.
If you want to configure another sensor setting for day/night/schedule mode, please click
Profile
to
open the Profile of exposure settings page as shown below.
Activated period: Select the mode this profile to apply to: Day mode, Night mode, or Schedule
mode. Please manually enter a range of time if you choose Schedule mode. Then click
Save
for the
configuration to take effect.
Auto
: If you set Exposure mode as
Auto
, the Exposure time and Gain control will not be
configurable since the sensor library will automatically adjust the value according to the ambient
light. Then you can configure iris mode as “indoor” or “outdoor” to reach the best image quality.
Note that when the
WDR Pro
function is enabled,
the Measurement window is not configurable.
NOTE:
■
AE Speed Adjustment
:
This function (Automatic Exposure) applies when you need to monitor fast changing lighting
conditions. For example, the camera may need to monitor a highway lane or entrance of a
parking area at night where cars passing by with their lights on can bring fast changes in light
levels. The same applies if the camera is installed on a vehicle, and when it needs to adapt to
fast changes of light when entering and leaving a tunnel. The speed level and sensitivity can be
manually adjusted.
Содержание CC8371-HV
Страница 82: ...VIVOTEK 82 User s Manual...
