Max. 45°
7
Connect the safety tether wire from the in-ceiling bracket to the main bracket.
6
Drive 2 screws (M3x20) to the mounting holes on the in-ceiling bracket.
Route and connect an Ethernet cable to the camera's RJ45 port, if you already
mount the ceiling panel.
8
Match the keyhole slots to the installed screws.
9
Install the camera and the main bracket by aligning the key slot holes with the
screw heads. Slide the main bracket to the left and secure the bracket with another
2 M3 screws.
Tilt the camera and use tools such as a spirit level to ensure the camera is installed
level.
10
11
12
Tighten the tilt retention screws when camera is level.
If the ceiling panel is thicker than 20mm, use the copper hex standoff spacers
instead.
if ≥
20mm
The bracket can also be installed without the in-ceiling bracket using the 4 holes
on the corners.
