VIVOTEK
User's Manual - 121
Applications > Tampering detection
This section explains how to set up camera tamper detection. With tamper detection, the
camera is capable of detecting incidents such as
redirection
,
blocking or defocusing
, or
even
spray paint
.
Please follow the steps below to set up the camera tamper detection function:
1. Click to select the checkbox before tampering conditions: Tampering detection, Image
too dark, Image too bright, and Image too blurry. Enter the tamper trigger duration.
(10 sec. ~ 10 min.). The duraction specifies the set of time before the tampering is
considered as a real alarm. This helps avoid false alarms by short-lived changes.
The tamper alarm will be triggered only when the tampering factor (the difference
between current frame and pre-saved background) exceeds the trigger threshold.
Conditions such as image too dark, too bright, or too blurry (defocused) can also be
configured as tampering conditions. The Trigger threshold determines how sensitive
your is tamper detection setting. Lower the threshold number, easier to trigger.
Too bright:
shining a flash light. The average lighting level of the scene is taken into
consideration.
Too dark
: covering the objective or spraying paint.
Too blurry
: blurry scene can be the result of strong interference on the device, such as
EMI interference.
2. You can configure Tampering Detection as a trigger element to the proactive event
configurations in
Event -> Event settings -> Trigger.
For example, when the camera is
tampered with, camera can be configured to send the pre- and post-event video clips to
a networked storage device. Please refer to page 105 for detailed information.
