S
1
8 8 8
2
3
2.4A
Down
Save
Memory
Charge
1.5A Charge
1.5A Charge
Up
Lock
LED Display
LED Control Panel
1.Reset operation
When system are abnormal ,or system show “RST”,It should do reset operation.How to reset:
hold press “Down” button until motor stop ,and press “Down” button 5s again,enter reset mode
automatically.Do not loose “Down” button during the operation.If loose “Down “button,system will stop
reset mode.When finishing reset,buzzer will make a sound to show reset successfully.
2.Up and down button operation
When touch UP button,desk move up until arrive desk top position.
When touch Down button,desk move down until arrive desk bottom position.
When shortly touch or button,desk will move short distance ,realize point move.
3.Position save and memory run
Led control panel can save 3 memory positions,save method as following:when run to specific
position,touch “S”button,indicator will show “S-”,and the “-”will flicker,while touch “1-3”button,save this
position to “1-3” button.
If run to memory spot,touch corresponding storage position “1-3”button.The indicator will show
corresponding position height,then run to storage corresponding position height automatically.During
run,any button can stop system.
4.Metric and British system switch
Hold touch “S”+“3”button for 5 s switch metric and British system,CN means cm,IH means inch.
5.Lock and unlock
Lock:Hold touch “LOCK”1 s,the indicator show “Loc”,this represents system has locked,can not do
any operation.
Unlock:Hold touch “LOCK”1 s,the indicator show from “Loc” to figure ,it represent system unlock.
6.Charge
When system enter dormancy mode or indicator light is off,it will start to charge automatically.
When indicator light is on,it will stop charge automatically.The first USB charge current is 2.4A.
The second USB charge is 1.5A.The third USB charge is 1.5A.