3
Shift Device Display
Hold "M" button for 2 seconds to shift device display. The desk frame height displays 73.0cm-122cm. The
stand height displays 39.0cm-52.0cm.
Switch the Display from Centimeter to Inch
The preset measurement shown on the display is cm. If you would like to change cm to inch, restart
the system by unplugging for at least 5 seconds and plug back in, then press “T” for at least 3 seconds.
The control panel will beep twice (beeps twice if changing to inch, and beeps once changing to cm) and
change the displayed unit. Repeat to switch back from inch to cm.
Sleep Mode
After resting for 1 minute, the screen will turn off to prevent accidental operation. Touch the screen to exit
sleep mode and operate the desk.
Collision Avoidance Settings
Press and hold the "M" and "T" buttons together for 5 seconds until you hear the control panel beep
twice indicating you are in the Collision Avoidance Settings Mode. The screen of the control panel
will display the current sensistivity level (level 3 by default). Press the up or down arrow to adjust the
desired sensitivity level. When you are finished selecting the new level, press the "M" butto n to save the
sensitivity level. The Collision Avoidance Settings Mode will automatically exit if there is no futher activity
within 8 seconds.
Note:
You must press the "M" button within 8 seconds of selecting the new sensitivity
level to save the new setting or the unit will revert to the previous setting level.
Collision Avoidance Sensitivity Levels:
0-5,
Default:
3
0: Turn off Collision Avoidance.
1-5: Sensitivity Setting - Level 1 is the lowest sensitivity and the level 5 is the highest sensitivity.
NOTES
•
Self-protection function: The unit will enter a protective mode should the system operate in
excess of 2 minutes with “HOT” on the controller display. The system will return to normal
operation after approximately 18 minutes.
•
Over-current protection mode: While operating, should the load on the desk exceed rated
specifications, the system will enter into over-current protection mode to protect the system
from damage. When this happens, the desk will move downward approximately 30mm and
come to a stop with the current height displayed.
•
Do NOT remove or reconnect power to reset the unit when in a protective or “HOT” state, as
this may damage the electronics.
TROUBLESHOOTING
Error Code Description/Resolution
ER1
Overload in downward direction. Disconnect and reconnect power.
ER2/HOT
Overheating in controller. Wait 18 minutes to allow controller to cool.
ER3
Motor connection fault. Reconnect motor and perform a desk reset.
ER5
ER6
RSR / RST
Desk weight limit exceeded. Decrease desk load before operating. If error appears after
reducing weight, the AC adapter may need to be replaced.
Connection error between control panel and electric monitor arm cable. Reconnect the
USB cable and the connecter. Ensure the USB cable is being routed away from the cable
sleeve and outside the cable clip to avoid any interference.
An error has occurred and entered reset mode for protection; complete reset process to
clear error.
Failure to follow these instructions may result in property damage and/or personal injury.
