2
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual and do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or
ELECTRICAL SAFETY INSTRUCTIONS
THIS PRODUCT IS POWERED BY ELECTRICITY. IN ORDER TO AVOID BURNS, FIRE AND ELECTRIC
SHOCK, PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY.
•
DO NOT CLEAN PRODUCT WHILE POWER IS CONNECTED.
•
DO NOT DISASSEMBLE OR REPLACE COMPONENTS WHILE POWER IS CONNECTED.
•
NEVER OPERATE THE SYSTEM WITH A DAMAGED CORD OR PLUG. PLEASE CONTACT YOUR
SELLER TO REPLACE DAMAGED PARTS.
•
NEVER OPERATE SYSTEM IN DAMP ENVIRONMENTS OR IF ANY ELECTRICAL COMPONENTS HAVE
MADE CONTACT WITH LIQUIDS.
•
ALTERATIONS OF THE GIVEN POWER UNIT ARE NOT ALLOWED.
•
OUTDOOR USE IS PROHIBITED.
OPERATING THE CONTROL PANEL
OPERATING INSTRUCTIONS
: When the system is powered on, you will hear a beep and the existing frame
height will be displayed on the control panel.
Note: If the control panel is used for the first time, please follow the reset process below before any
further operation.
Reset Mode
Frame:
While the unit is powered on, press the down arrow until the desk moves to the fully lowered
position. Restart the system by unplugging for at least 5 seconds and plug back in, then hold the down
arrow. RST will be displayed. Continue to hold down the arrow while the desk moves to the lowest
position, then raises approximately 5mm and stops. The frame reset process is complete.
Stand:
When the monitor stand height display is incorrect, run it to the highest point 52.0cm and then
lowest point 39.0cm, the monitor stand will self-adjust the height level.
Upward and Downward Movement
Press and hold the up or down arrow until the desk reaches the desired height.
Timed Reminder Mode
To set the timer, press “T”. The display will flash “0.5h” representing 30 minutes. Press “T” repeatedly to
increase 0.5 hours at a time. The maximum timer setting is 2 hours. The timer is set when the display
stops flashing and the indicator light in the top right corner of the controller is on. When the timer has
reached the set time, three beeps will sound reminding the user to adjust the working position. Once the
timer setting has expired, the unit’s timer is canceled. To deactivate the timer, press “T” five times or until
the current height is displayed and the indicator light in the upper right corner is turned off.
Memory Mode
To store a device height in the control panel's memory, first press “M”. “S-” will be displayed. Now press
“1”, “2”, or “3” within five seconds to store the current device height in memory. Shift Device Display and
repeat to set second device to the same memory. Each number can store a different height. Once desired
memories are set, you can recall any of the three height settings by pressing the corresponding number
button. Touching any button will stop the automatic adjustment.
Note:
In the automatic operation for one memory setting, If the user presses a different memory setting
when one device reaches the position and the other one doesn't, it will cause one pause situation. Eg:
The desk and the monitor stand start running when pressing "1". The desk moves faster so it stops first. If
the user presses "2" or "3" meanwhile, the desk will start running again and the monitor stand will stop
running (any button to pause). The memory settings work normally when both devices are paused.
WARNING!
