3
STEP 2 (Optional)
Due to variance in manufacturing, our VESA adapter
may exhibit a slightly loose fit on your monitor. If you
find this is the case and you are not satisfied, you can
use the U-shaped adhesive pad (
D
) provided to create a
more desirable fit.
Release VESA adapter (
A
) from monitor using the
release tab. Apply U-shaped adhesive pad (
D
) to the
monitor male adapter plug as shown. Use your finger
to smooth out adhesive pad (
D
) to make sure it lies
flat on the monitor male adapter plug. Reinsert VESA
adapter (
A
) onto monitor by repeating Step 1.
Note:
Your monitor will be fully secured either way, and
there is no risk of it falling off as long as the adapter
“snaps” onto the monitor in Step 1.
Depending on the thickness of your monitor mount VESA
plate (very thick VESA plates may require no washers), it
may be necessary to remove M4 washers (
C
) in order for
the M4x10mm thumbscrews (
B
) to fully engage the threads
in VESA adapter (
A
). The best way to determine this is to
check that the M4x10mm thumbscrew (
B
) is protruding out
the back of VESA adapter (
A
), as shown in figure below. Be
sure to also check that removing M4 washers (
C
) does not
allow the M4x10mm thumbscrew (
B
) to contact the back of
your monitor. If you experience difficulties, please contact
customer support.
IMPORTANT!
STEP 3
Mount your monitor with VESA adapter (
A
) now
attached from Step 1 to your VESA monitor mount and
secure using 3X - M4 washers (
C
) and 1X - M4x10mm
thumbscrew (
B
) per hole.
Note:
Once the thumbscrews are finger-tight, it
is not necessary, but recommended to tighten
slightly more with a phillips screwdriver.
D
D
