32
DU6871/DW6851/DX6831 DLP Projector - User's Manual
OSD Menu - PICTURE
Picture Mode
Contrast
Hue
Brightness
Saturation
Sharpness
Color
Noise Reduction
< 100 >
Enter
Overscan
Aspect Ratio
Auto Sync
VGA Setup
< Off >
< 16:10 >
Enter
Execute
INPUT
SERVICE
ALIGNMENT
CONTROL
LAMP
PICTURE
< Video >
< 100 >
< 100 >
< 100 >
< 0 >
< 15 >
•
Picture Mode
Use ◄► to select a picture mode.
High Bright:
The highest brightness output mode is suitable for the occasion where
high brightness is needed�
Presentation:
The best image effect is suitable for the presentation or picture�
Video:
The best color mode is suitable for play of the video�
•
Contrast
Use ◄► to adjust the contrast of the projected image.
Note:
• The brightness and contrast controls affect each other. To obtain the best setting, fine-tune of the
brightness setting might be needed after adjustment of the contrast�
•
Brightness
Use ◄► to increase or decrease the brightness of the image.
•
Saturation
Use ◄► to adjust the saturation level of the color (the higher the level, the higher the
saturation)�
•
Hue
Use ◄► to adjust the level of hue for reproduction of the true color.
•
Gamma
When the ambient light is too bright and may affect the display of the details in the
darker area of the image, you can select from the following gamma options to adjust
the chrominance of the image�
Film:
Set the chrominance correction to approximately Gamma 2�2�
Graphics:
This options is used for the PC presentation that needs higher brightness at
the cost of the gray scale accuracy�
Video:
This is similar to the Film option, but there is a different in the dark area of the
image to correspond to the function that the projector uses for creation of the image�
Linear:
Set Gamma to linear chrominance correction�
2�2:
Set the chrominance correction to 2�2�
