7
Connect the smaller end of the USB cable into the USB port of your camera.
Connect the other end of the USB cable to the AC Charger.
Plug the AC Charger into a power socket.
The
camera’s charge light will turn on while the battery is charging.
The charge light will turn off once the battery is fully charged.
Note
:
Some features, such as Flash, will not work if the battery power level is low.
When the battery power is empty the battery icon turns red and ‘Low Battery’ flashes on
the LCD screen. The camcorder automatically turns off a few seconds later.
The energy status of the power is displayed on LCD as shown below:
Full battery power
Medium battery power
Low battery power
SD MEMORY CARD
Make sure an SD Memory Card (up to 32 GB) has been properly installed into your camera.
SD card not included. To properly install the SD Memory Card:
1)
Locate the SD Memory Card slot on the bottom of the camera, inside the battery
compartment. Note that the SD icon next to the SD Memory Card slot indicates the direction
in which to place the SD Card. See images below: 1 and 2.
2)
Push the SD Memory Card into the slot in the direction as shown by the SD icon on the
camera.
Push the SD Memory Card until you hear a slight clicking sound. This indicates the SD card
has been inserted correctly. See images below: 3 and 4.
