Vivint SR1410, Инструкция по установке и эксплуатации

Страница: 34 / 38

SR1410 Installation and User Guide Page 34
SR1410 Installation & User Guide Ver. 0.01

Point-to-Point Configurations
– In a point-to-point configuration, the alignment process requires
two people at each end of the link. The use of cell phones or two-way radio communication may help
with coordination. To start, you can just point the antennas at each other, using binoculars or a
compass to set the general direction. For accurate alignment, you must set the transmitter to output in
continuous transmit mode, and set the receiver to be in continuous receive frame mode. As the
antenna moves horizontally and vertically, the RSSI values vary and are indicated on the management
interface.

Point-to-Multipoint Configurations
– In a point-to-multipoint configuration all Slave routers must
be aligned with the Master router antenna. The alignment process is the same as in point-to-point
links, but only the Slave end of the link requires the alignment.
Steps for aligning antenna:
Initialize the transmitting radio to be in continuous transmit mode. The interface shall be enabled at the
main screen as shown below, by selecting the red rectangle on mouse-over
2.4 Command Line Interface
Commands that perform the most functions are:
ifconfig – Network related
iwpriv – WLAN related
iwconfig – WLAN related
iptables – Traffic filter, classification, forwarding, NAT
tc – traffic queuing
2.4.1 Getting Help on CLI Commands
2.4.1.1 ifconfig
root@Vivint:~# ifconfig --help
BusyBox v1.11.2 (2010-08-07 08:17:48 PDT) multi-call binary
Usage: ifconfig [-a] interface [address]
Configure a network interface
Options:
[add ADDRESS[/PREFIXLEN]]
[del ADDRESS[/PREFIXLEN]]
[[-]broadcast [ADDRESS]] [[-]pointopoint [ADDRESS]]
[netmask ADDRESS] [dstaddr ADDRESS]
[hw ether ADDRESS] [metric NN] [mtu NN]