Vivint SR1410, Инструкция по установке и эксплуатации, Страница: 31 / 38

SR1410 Installation and User Guide Page 31
SR1410 Installation & User Guide Ver. 0.01
2.0 Hardware Installation
The SR1410 Outdoor Wireless Access Point/Router is designed to be deployed outdoors, exposed to all
elements (extreme heat or sun, rain, snow, ice, cold) and mounted on a wall, pole, or mast. The SR1410
is supplied complete with its own mounting hardware kit for attaching the unit to a 1-2.5” diameter metal
pole or tube or as part of a radio mast or tower structure.
The supplied SR1410 48V power supply is suitable for outdoor use.
The optional SR1410 indoor-rated Power over Ethernet injector (Vivint part #9004H49000) must be
deployed indoors, or within an enclosure protecting it from the elements.
Hardware installation of the wireless router involves these steps:
1. Mount the SR1410 unit on a wall, pole, mast, or tower using the mounting hardware.
2. Mount external antennas on the same supporting structure as the router and connect them
to the router unit.
3. Connect a grounding wire to the SR1410 unit.
4. Connect the Ethernet cable to the SR1410 unit.
5. Connect the power supply to the SR1410, and to an AC power source.
6. Connect the power injector (if used) to the Ethernet cable, a local LAN switch, and an AC
power source.
7. Align antennas at both ends of the link.
Before mounting antennas to set up your wireless links, be sure you have selected appropriate locations
for each antenna. Follow the guidance and information in
“Link Planning.”
Also before mounting units in their intended locations, you should first configure the devices as
described in Section 1.5
“System Setup” and Section 1.6 , “System
Configuration.”
You should also test
the basic operation of the wireless router links in a controlled environment over a very short range, as
described in
“Testing Basic Link Operation”, Section 2.1.1
.
2.1 Before Installing
Before installing your SR1410 Outdoor Wireless Access Point/Router, verify that you have the
following:

Outdoor Ethernet cable of required length of 50 meters (164 feet), or a cable meeting the pin-out
configuration specification to the required length (not to exceed 90 meters total), shielded CAT-5
Ethernet 8-pin DIN to RJ-45

Power supply shipped with the SR1410

An appropriate and stable mounting location

A suitable electrical grounding point (on AP mounting mast/pole)

Appropriate tools (wrench for mounting bolts, Phillips head screwdriver, DC voltmeter (if RSSI-
based link alignment is to be performed))
Mounting items not supplied with the SR1410 — screws, bolts, and straps — should be available and at
hand prior to installation.