Page
7
of
15
The Pandora360 comes in a wellboard box lined with specially cast plastic foam lining.
Start by cutting the box sealing tape and take out the parts. Each box includes the following
parts:
One Pandora360 Node.
One bag with Strain Relief parts,
One bag with Gasket and plugs for complete weather proofing of the different cable
connections.
4.3. Installing
The Pandora360 node is installed as follows:
4.3.1. Pole Installation
Pandora360 installer's Tools will direct the installer where the unit can be located on the roof
(typically a polygon is defined). The unit will need to report it's correct GPS position back to the
IT systems to verify the node is installed at the correct site. (If this is not verified the installer
will not be able to complete the installation process.) This roof-top location should be a place
close to the top of the roof that allows for line-of-sight to neighboring nodes as provided by the
planning data.
On the roof:
1.
Mark the proper location for the pole as indicated by the Installer's Tool.
2.
Check that line-of-site to adjacent Pandora360s are free.
3.
Mount the foot and the pole on the roof so that the pole is truly vertical. (Make sure that
the installation is done according to local regulations to prevent leaks etc.)
4.
Mount the support struts for the pole.
4.3.2. Cable Installation
Use the following cable types for the installation:
Connection
Cable type/Part
Number
Name
PoE & LAN
ECB0012/xxx
24 AWG CAT5e outdoor SFTP (Shielded Foiled
Twisted Pair) cable, black
Optical Fibre
Cable
ACC0004/xxx
LC-LC Single mode 1310 nm with short fanout
because of strain relief for outdoor use
DC & I/O
ECB0014/xxx
(6x) 20 AWG shielded (foil and braid)
