10
2.2.
Rear Panel Connections
The CLV-401 Camera Link
TM
Video Splitter rear panel is shown in Figure 2-3. The rear
panel contains the 26-pin MDR video connector for the slave frame grabber, a power on
indicator, on-off switch, and DC power jack. DC power jack accepts 5-7 volts DC.
Polarity is center-positive.
The MDR-26 connector is 3M p/n 10226-55G3VC as specified in the Camera Link Spec.
Figure 2-2 identifies the MDR-26 pin positions.
SLAVE FRAME GRABBER
POWER
5-7 VDC
ON
OFF
Figure 2-3: CLV-401 Rear Panel
2.3.
Video Connector Signals
The MDR-26 video connector signal assignments comply with the Camera Link
TM
“base”
configuration. The
camera
connector signal assignments correspond to the frame grabber
interface defined in the Camera Link Specification. Conversely, the
frame grabber
connector assignments are as defined for the camera interface in the Camera Link
Specification. This arrangement provides compatibility with standard Camera Link
TM
cables.
Table 2-1 identifies the signal assignments for the MDR-26 video connectors.
