Vivax WFL-1001, Руководство по обслуживанию

Страница: 55 / 66

P.55
6.5 Self-check
Push the buttons of function and pre-washing without loosening, in the meantime screw
the program knob to the position of cotton and keep 3s, then the program will be in the
state of self test. When the buzzer toots, all the indicating lights glitter 3 times ( pushing
0.5s, the 0.5s light is on and off), then the lights are on all the time. When the knob screw
to the following position in this time and push the button of start/off, the test is effective.
1. Delay washing test (cotton normal water):the maximum inlet water time is 10s.
2. Main washing test(cotton 40
℃
): the maximum inlet water time is 10s.
3. Washing test(cotton 60
℃
): the maximum inlet water time is 10s.
4.Heating test(cotton 90
℃
): estimate whether the water level is 1, if not, adding water to
1, then begin to heat in the maximum of 10 minutes.
5.Tub leaking test(speedy washing 30
℃
): estimate whether the water level is 1, if not,
adding water to 1, according to cycle of clockwise 10s-stop 2s-anticlockwise 10s to test
in the rotate speed of 250rpm (
f
ault alarm E6/E7).
6. Drain test (single drain): if the water level is below 1, it is plus 40s (malfunction alarm
E3).
7. Dehydration (single dehydration): judge whether the water level is below 1, if not,
drain water until it is below the 1 plus 20s, then dehydrate in the maximum of speed
(unbalanced test is needless), the maximum time is 10 minutes(fault alarm E5).
NOTE:
1) The tests foregoing are reversible.
2) It is need to close the door lock before each test, or else the door clock is malfunction
alarm E1.
3) The knob can be screwed to every position, the corresponding test is valid once pushing
the start/pause button.
4) If the knob is not in the position of that test, there is not responsive.
Exit need to close the power.
6.6 Marketing-show (no-water testing)
Target: in order to display the washer’s operation in the supermarket, set up display mode.
Operation program: push the fu pre-washing button and screw the knob to 40
℃
,
keeping 3 minutes, when the buzzer toot, it enter the sales display mode. In the mode, the
washer without and the heater without power, run the two minutes standard cotton
w washing program and three minutes dehydration program after pushing the
start/pause button, then stop, if you push the start/pause button again, the operation repeat.
Exit need to cut off the power.
6.TROUBLESHOOTING