Vivax CF-180 S, Руководство пользователя

Страница: 63 / 88

VIVAX
ENG
.
14
◆
For the first time you install your refrigerator, set the thermostat knob at “
Med
”.
Give your refrigerator time to cool down completely before adding food. It is the
best to wait 24 hours before adding food. The thermostat knob controls the
temperature.
For the first time you install your refrigerator, set the thermostat knob at “
Med
”.
Give your refrigerator time to cool down completely before adding food. It is the
best to wait 24 hours before adding food. The thermostat knob controls the
temperature.
◆ When the Thermostat knob is turned up to the end position, below the
"Min" position, the Refrigerator will stop cooling
.
WARNING: In the lowest Thermostat position, although the fridge is not
cooling, it does not mean that the device is disconnected from the power
supply. For cleaning and maintenance, to disconnect the power supply
pull the power plug out of the socket!
Noise Inside the Unit!
You may notice that your unit makes some unusual noises. Most of these are
perfectly normal, but you should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the cooling
system. It has become more pronounced since the introduction of CFC free gases.
This is not a fault and will not affect the performance of your unit. This is the
compressor motor working, as it pumps the refrigerant around the system.
Change the Light Bulb
The LED lamp must be replaced by authorized service
The first Start
Cleaning Before Use
Wipe the inside of the unit with a weak solution of
bicarbonate soda. Then rinse with warm water using a
'Wrung-out' sponge or cloth. Wash the shelves and
salad bin in warm soapy water and dry completely
before replacing in the unit.
Clean the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning
section
◆
Before Plugging in
You must check that you have a socket which is compatible with
the plug supplied with the unit.
◆
Before Turning On!
Do not turn on until one hour after moving the unit.
The refrigerator shall run 2 to 3 hours before loading fresh or frozen foods; the
refrigerator shall run for more than 4 hours in summer in advance considering that
the ambient temperature is high