Vivax Metrotech Loc3-25Tx, Руководство пользователя

Страница: 4 / 8

™
3. Transmitter Mode
WARNING
Always connect the transmitter to a target line following all the company procedures. This operation
should only be performed by authorized personnel. Always make connections before switching on the
unit. Switch off before disconnecting the transmitter.
NOTE
When the transmitter is powered on without connection leads, a “NO CONNECTION” message will
appear. Power off the transmitter and insert the connection leads, and procced with power up.
NO CONNECTION
3.1 Direct Connection Mode
The Direct Connection mode is automatically selected by plugging a connection lead into the output socket. An icon confirming
the direct connection mode is shown on the display. The wave in the icon fluctuates when the transmitter is operating. The direct
connection lead consists of two colored cables with clips and covers. The red clip must be connected to the conductor being
located, the black clip to a suitable ground such as the ground stake provided with the transmitter.
A good connection is indicated by a change in the beep rate from the speaker and the current reading on the display.
FUSE
Wherever a direct connection can be safely made without the risk of injury, damage to the customer’s plant, or the transmitter, it
is the best way of applying the transmitter’s signal.
The positioning of the ground connection can also influence the degree of coupling experienced. Ground connections generally
should not be made to other pipes or cables or above ground metallic structures such as wire fences. In general, the lower the
frequency is, the further the signal will travel, and the less signal-coupling will occur. The most common frequencies used for
direct connection are between 512 Hz/640 Hz and 8 kHz.
Regulations in many countries require that power output is limited above specific frequencies. The Loc3 series 5-watt,10-watt,
and 25-watt transmitters enable frequencies below 45 kHz to be transmitted using as much as 5-watts,10-watts or 25-watt
output, depending on your transmitter, but frequencies over 45 kHz are restricted to 1-watt. Using direct connection and the
higher power at the low frequencies helps significantly in achieving greater location distances. Direct connections should not be
made to cables carrying greater than 25V (or as your safety practices allow). The transmitter is protected (250V fuse) from stray
currents that may exist on the target line.
Page 4