Vivax Metrotech Loc3-25Tx, Руководство пользователя

Страница: 3 / 8

www.vivax-metrotech.com
The Loc3-25Tx Transmitter Insert
™
NOTE
The 25-watt transmitter ships with the Li-ion battery tray as a standard part. Alkaline can be used with
the 25-watt transmitter, but the power output will be limited to 10-watts.
WARNING
Use only Vivax-Metrotech recommended charger.
Do not attempt to replace the rechargeable batteries or remove battery covers.
Return to Vivax-Metrotech or a Vivax-Metrotech approved service center for replacement.
2.1 Charging the Transmitter Battery Tray
The rechargeable battery tray can be charged while attached to the transmitter or on its own.
1. Connect the charger to the charging socket on the transmitter's side or directly into the battery tray's charging socket.
2. The LED on the charger will glow red while charging and turn green when fully charged.
FUSE
Internal Charger Socket
Plug the charger into the charging socket on the side of the transmitter or directly into the battery tray.
NOTE
The rechargeable tray cannot be charged from a 12V DC source.
WARNING
Only use a charger supplied by Vivax-Metrotech Corp. Using non-approved chargers may result in
damage to the equipment or overheating/explosion.
The battery condition (charge) is displayed on the left side of the display.
Follow instructions detailed in the General Safety & Care Information section of this manual. Only use the battery charger
supplied as using an unapproved charger may damage the battery pack and may cause overheating.
2.2 Removing and Installing the Battery Tray
Removing the battery tray Installing the battery tray
FUSE
FUSE
1. Pull out the bottom of the catch
2. Lift the transmitter from the battery tray 1. Lower the transmitter into the tray
2. Push up button underneath the catch while holding it up.
3. Push in the bottom of the catch until you hear a positive
“click."
Page 3