P/N: 4.04.000073
page 3 of 10
1.2.2
Replacing the Alkaline Battery
To access batteries
– undo the two latches that are locking the battery cover
To remove batteries
– remove the battery holder from the inside of the unit
Replace batteries with new batteries of the same type, be sure not to mix old and new batteries
Do not
use rechargeable batteries in the alkaline battery tray. Ensure that batteries are inserted the correct
way (see label and molded “
” and “
” in the bottom of the tray)
Refit the battery tray
– then close the battery cover
WARNING
Alkaline Batteries
– insert alkaline batteries (x 8) as shown:
1.2.3
Rechargeable Batteries
Do not
attempt to replace the rechargeable batteries or remove battery covers
– return to Vivax-Metrotech
or a Vivax-Metrotech approved service centers for replacement.
WARNING
Use only Vivax-Metrotech recommended charger.
1.2.4
Re-fitting the Battery Tray
To close the battery compartment
– place the two catches into their position, then close the catches.
1.2.5
Rechargeable Battery Pack Charging and Disposal
Follow the instructions in the General Safety & Care section portion of this document.
Only use the battery charger supplied with the battery. Using a non-approved charger may damage the battery
pack and could cause overheating.
The rechargeable battery pack must be connected to the transmitter in order to charge. Connect the charger
to the charging socket on the inside of the transmitter and connect the charger to a suitable mains socket.
The LED on the charger will show a red light indicating that the charge cycle is in progress. When the batteries
are fully charged the LED will change to green.
NOTE
Rechargeable pack cannot be charged from a 12V DC source.
