Anywave Communication Technologies
Vivace MPEG2 Encoder User Manual
6
6 / 37
Powered by
5
Configuration
5.1
Overview
The configuration page of the User Interface is shown below. Each channel on the
encoder has its own configuration menu. (the example below shows an 8 channel
encoder model)
To change a configuration for any channel, select the tab that goes with that channel.
Each channel is associated with a specific input interface. Refer to the model you have
to associate the physical interface with the channel number.
Once you make your changes to the parameters you wish, you must select the save
button. The configuration changes do not take effect until you start or restart a channel
on the Control page. A warning is shown on screen when changes are made but not
saved. However, if you ignore that warning and navigate to a different menu, then any
changes made will be lost.
When first setting up channels, it is suggested
to select “reset to defaults” to have a
good starting point with typical values
. There is also a defaults button for individual
channels, if you wish to only set defaults for a given channel.
