IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-844-469-8482 for
assistance
Model # 7LIECH-SC-SSF:Page 8
INSTALLATION
To prevent accidental tip hazard, dispenser must be securely anchored to
wall as shown.
1. Place dispenser upright.
2. Locate dispenser on a hard and level surface in
a cool shaded location near a grounded wall
outlet.
Notice: Do NOT plug in power cord yet.
3. Position dispenser so the back is at least 4
inches from wall and there are at least 4 inches
of clearance on both sides.
4. Install Wall Mount Strap to prevent accidental tip
over:
•
Unclip strap from back of dispenser.
•
Mount strap 25 inches up from floor directly
to wall stud with screw (See illustration A)
If stud is not available, insert and turn
anchor directly into sheet rock using a
Philips screwdriver (DO NOT drill hole into
sheet rock first when using this anchor).
Secure strap by installing screw through
washer, then eyelet in strap and into wall
mounted anchor. (See illustration B)
•
Position cooler in place.
•
Clip strap onto back of cooler to right or
left side. (See illustration C).
•
Adjust length of strap so the dispenser can
NOT move forward.
Note – Dispenser can be positioned in a corner
but still requires Wall Mount Strap to be
installed. Lengthen strap so that once installed
the dispenser cannot move forward.
