VITO VIML70, Инструкция по эксплуатации, Страница: 51 / 72

Question/problem - cause
Cause
Solution
The combustion engine does not start:
•
There is no fuel in the tank;
The fuel line is clogged;
•
The fuel lever is set to OFF position;
•
The fuel in the tank is of poor quality, has water, is
dirty or is already old;
•
The cap has been removed from the spark plug;
The spark plug wire is not connected;
•
The spark plug has soot or is damaged; Wrong gap
between the electrodes;
•
The engine switch is not in the "ON" position;
•
There isn’t enough compression. Little force is
needed to pull the recoil starter.
•
The air filter is dirty;
•
The combustion engine is “wet” due to many
attempts for starting it;
•
Very low engine oil level;
The appliance is too tilted;
•
The choke lever is not set to CLOSE position;
•
Fill the tank with fuel;
Clean the fuel line;
•
Set the fuel lever to OPEN position;
•
Use new fuel;
•
Attach the cap to the spark plug;
Connect it;
•
Clean/replace the spark plug;
Adjust the gap between the electrodes;
•
Set the ON/OFF switch to “ON” position;
•
Check that the spark plug is tight. If not, tighten it;
•
Clean/replace the air filter;
•
Unscrew the spark plug and dry it, pull the recoil starter
several times, with the spark plug unscrewed;
•
Fill oil to the appropriate level;
Place the appliance on flat floor;
•
Set the choke lever to CLOSE position;
Start-up difficulties or reduced combustion engine
power:
•
There is water in the fuel tank and carburetor;
•
The fuel tank is dirty;
•
The air filter is dirty;
•
The spark plug has soot;
•
Empty the fuel tank;
•
Clean the fuel tank;
•
Clean/replace the air filter;
•
Clean/replace the spark plug;
The engine runs irregularly:
•
The air filter is dirty;
•
Clean/replace the air filter;
The combustion engine overheats:
•
Cooling fins are dirty;
•
Engine oil level too low;
•
Clean the cooling fins;
•
Top up your engine oil level;
The high-pressure washer is smoking:
•
The air filter is dirty;
•
Clean/replace the air filter;
Strong vibrations while operating:
•
Loose engine housing;
•
Tighten the engine fixing screw;
There is no water coming out of the nozzle:
•
The water supply is turned off;
•
The pump is sucking air;
•
The lance or nozzle are clogged;
•
Turn the water supply on;
•
Check suction components;
•
Clean the nozzle/lance;
Irregular pressure:
•
The pump is sucking air;
•
Unsuitable or worn-out nozzle;
•
Check if there is air coming into the pump or suction
pipes;
•
Replace the nozzle;