VITO VIASL40, Инструкция по эксплуатации

Страница: 25 / 40

Do not run the vacuum cleaner for more than 4 hours,
including rest breaks. Make sure the vacuum cleaner is
regularly switched off to allow the motor to cool down
(every 15 min switch off for 1 min). Otherwise, you may
damage the motor.
Never use the appliance for vacuuming:
•
Hazardous dust to health;
•
Hot or burning materials such as cigarettes, matches or
hot ashes;
•
Flammable or combustible liquids, such as petrol,
solvents, acids or bleach;
•
Combustible or explosive dusts, e.g. magnesium dust;
•
Sharp objects.
Never use the vacuum cleaner if the suction power is too
low. If this happens, check that the filter bag is full and
check the condition of the filters (refer to maintenance
instructions). Also check if there are any blockages or
clogging in the hose, tube or suction accessories.
Avoid vacuuming up debris and materials that could reduce
airflow and block or clog accessories.
Do not use the cleaner if it does not operate normally. If the
problem persists, have the vacuum cleaner serviced by the
brand technical assistance.
1. Unwind the power cord and plug it into the socket;
2. Fit the vacuuming accessory according to the waste to
be vacuumed;
3. Set the "ON/OFF" switch (8) to the "I" position;
To switch off the vacuuming cleaner:
4. Set the "ON/OFF" switch to the "O" position and unplug
the power cord. Always switch the vacuum cleaner off
before unplugging the power cord;
5. Wind the power cord.
1. Set the "ON/OFF" switch to the “0" position;
2. Plug the power tool's plug into the vacuum cleaner's
socket and the tube;
3. Set the "ON/OFF" switch to the “II" position .
In this mode the vacuum cleaner will run 2 to 8
seconds longer than the power tool.
1. Fit the dust and solids floor nozzle (1) and adjust its
brush position according to the type of floor to be
vacuumed;
2. Keep the HEPA filter in place inside the vacuum cleaner.
1. Fit the floor nozzle for liquids.
2. Keep the HEPA filter in place inside the vacuum cleaner.
Whenever the tank is full, stop the vacuum cleaner and
empty.
When vacuuming dust or solid waste:
1. Switch off the vacuum cleaner;
2. Undo the fastening latches (11) and remove the vacuum
cleaner head (10);
3. Pour the tank waste into a bag or box for disposal;
4. Once empty, place the tank on a vertical position and
also the filter bag;
5. Refit the vacuum cleaner head and switch it on again.
When vacuuming liquids:
1. Switch off the vacuum cleaner;
2. Undo the fastening latches (11) and remove the vacuum
cleaner head (10);
3. Empty the waste into a container;
4. Refit the vacuum cleaner head and switch it on again.