3)
O
peration
a) Keep your face and body away from the blowing opening.
b) Do not allow hands or any other part of the body or clothing inside the blowing
opening, discharge chute, or near any moving part.
c) Keep proper balance and footing at all times. Do not overreach. Never stand at a
higher level than the base of the machine. Always be sure of your footing on
slopes. Walk; never run whilst using the appliance.
d) Always stand clear of the discharge zone when operating this machine.
e) If the machine should start making any unusual noise or vibration, immediately
shut off the power source and allow the machine to stop. Remove the battery and
take the following steps before restarting and operating the machine:
i)
inspect for damage;
ii)
replace or repair any damaged parts;
iii)
check for and tighten any loose parts.
f) Do not allow processed material to build up in the discharge zone; this may
prevent proper discharge and can result in kickback of material through the intake
opening.
g) If the machine becomes clogged, shut-off the power source and disconnect the
machine from supply before cleaning debris.
h) Never operate the machine with defective guards or shields, or without safety
devices, for example the front tube in place.
i) Keep the battery compartment clean of debris and other accumulations to
prevent damage to the power source or possible fire.
j) Do not transport this machine while the power source is running.
k) Always remove the battery:
•
Whenever the machine is left by the user.
•
Before clearing a blockage.
•
Before checking, cleaning or working on the machine.
•
After striking a foreign object to inspect the machine for damage.
•
If the machine starts to vibrate abnormally, for immediately check.
l)
Do not tilt the machine while the power source is running.
4
