17
16
15
11
10
18
14
13
12
www.vitesse.ru
P/3
P/4
•
How to use connecting tubes and curved wand?
When connecting, insert the bigger end of the
connecting tube into air flow handle and then swivel it
for firm connection. (fig.10)
•
Connection of the tubes. Refer to the above
said.(fig.10)
•
Connection of connecting tube with floor brush. For
connection, insert the smaller end of connecting tube
into the tube on the floor brush, and then swivel it for firm
connection.(fig.11)
•
Regarding the connection of connecting tubes with
crevice nozzle, refer to the above said.(fig.10)
•
Power Cord
The power cord can be pulled out as long as it is marked
with yellow color. It is forbidden to exceed the red mark
(fig.12)
•
Power button
After plugging into electrical power outlet, press the
power button on the body cover to control start and
stop. (fig.13)
•
Regulation of suction power
To control the input power and suction power by
regulating the knobs. (fig.14)
To control the suction power by the air flow regulator on
the air flow handle.
Suction power will decrease if the button is pushed
ahead; suction power will increase if the button is
pushed backwards.(fig.15)
•
To clean the corner or crevice places, you can use the
nozzle(fig.16)
•
For couch, curtain or decoration surfaces, the sofa
brush should be used. And the floor brush is used for
blanket and floor.(fig.17)
•
Cleaning dust bag and replacing parts.
When the dust-full indicator on top of the body is with red
indications, it means the dust bag is full of dust. You
need to replace paper dust bag and clean the air filter
when clogged.(fig.18)
USING INSTRUCTION
•
Replacing the dust bag
1) Lift up by the front cover clamp to open the front
cover (fig.19)
2) To take out the dust bag from dust bag
holder.(fig.20)
3) If you use a paper dust bag, replace it with a new
one. If a cloth dust bag, take out the clip and open the
dust bag to empty dust then insert it back to its
position for further use by sealing the bag well with
the clip. (fig.21)
4) Assembling the dust bag, you should press the
clamp button on the bag holder, and insert the dust
bag into the two slots, then release the button to clip
the dust bag. (Fig 22)
5) If the dust bag is broken, replace it immediately.
•
Replacing the front cover and turn the dust bag holder
over to take out the filter for cleaning or replace a new
one.(fig.23)
•
Replacing the air outlet filter
Press the clamp position of the air outlet cover to
discharge the air outlet cover for clean up or a new
replacement.(fig.24)
•
Cleaning the air inlet and outlet filter.(fig.25)
1) Put the filter into running water for rinsing.
2) Remove some water by cleaning the filter with towel,
and then dry it in cool place.
3) Dry the filter in a ventilation place; take care not to
bake it so as to avoid being deformed by high
temperature.
•
Power cord rewinding
When not in use, unplug from the electrical power outlet
and then press the cord rewinding button to retract the
power cord.(fig .26)
•
For storage
Insert the plastic holder of the Connecting tube into the
unit base or holder hook on the back unit. (Fig.27)
•
Put the combination crevice nozzle in the accessory
hole in the bottom of the body after finishing
suction.(fig.28)
19
21
20
22
23
24
26
27
28
25
