Vitek VT-EH Series, Инструкция по эксплуатации

Страница: 32 / 81

VT-EH Series DVRs________________________________________________________________________________
32
HOW TO OBTAIN AN IP ADDRESS
One of the easiest ways to obtain an IP address for your DVR is to use the built-in DHCP feature of your DVR.
HOW TO SET UP DHCP
The purpose of DHCP is to obtain all of the network information from the connected router. In most cases, the best way to
do this is to cycle the DHCP feature which means turn it on, then off again. This will get the network information from the
router, and then by turning DHCP off in the DVR, it will lock that address to the DVR.
Using the DHCP Feature:
1)
Go to your DVR‘s ‗main‘ menu, 
System Setup

Network
2)
‗IP SETUP‘ should be selected by default. To the right, ‗DHCP‘ is listed. If it is ‗checked‘, uncheck it, then select
‗Apply‘ at the bottom of the screen. You should get a pop-up indicating the network is rebooting. (If DHCP was
unchecked, see below)
3)
Once the network reboots, go back and ‗check‘ DHCP and select Apply. Again, the network will reboot.
4)
Make note of your DVR‘s IP address; you will need this for port forwarding.
5)
Now, go back and ‗uncheck‘ DHCP; this will set your DVR‘s IP address to STATIC.
If DHCP is ‘unchecked’ , select it, then select ‗Apply‘ at the bottom of the screen. You should get a pop-up indicating the
network is rebooting. Make note of your DVR‘s IP address; you will need this for port forwarding.
Now, go back and ‗uncheck‘ DHCP; this will set your DVR‘s IP address to STATIC.